Steam Distillation of Eugenol Essay

Published: 2020-01-03 20:42:55
487 words
2 pages
printer Print
essay essay

Category: Distillation

Type of paper: Essay

This essay has been submitted by a student. This is not an example of the work written by our professional essay writers.

Hey! We can write a custom essay for you.

All possible types of assignments. Written by academics

Introduction: This experiment involves an extraction of a natural product using the techniques of steam distillation. The principle component of oil of cloves is an aromatic compound, which is identified by thin layer chromatography (TLC).

Eugenol is widely used in dentistry, due to its analgesic, antiseptic balsamic qualities. It is ideal for curative for pulp hyperemia (the soft, sensitive substance underneath the enamel and dentine of a tooth) and pulp its. In dentistry eugenol is also used to cover cavities, fill canals, etc. It also keeps food fresh and kills off bacteria and viruses. Eugenol helps keep meat fresh and prevents stomach upset, diarrhea, and wound infections. In addition, it might play a part in relieving indigestion, controlling diarrhea, and healing cuts and bites.

Eugenol is the main active ingredient in cloves.


1. In a 250 mL round bottom flask, place 10.0g of ground cloves and 80 mL of water. Set up for a simple distillation

2. Heat to boiling and collect the distillate until you no longer see droplets of organic liquid coming out of the condenser (about 40 minutes).

3. Place the distillate in a separatory funnel and extract with three 10 mL portions of Dichloromethane

4. Combine the dichloromethane extracts and dry over Sodium Sulfate.

5. Examine the purity of the extract using thin-layer chromatography (TLC). Spot a small sample of the extract using a capillary spotter about 1 cm from the end of TLC plate.

6. Visualize using a UV light and mark the visualized spots with a pencil.

7. Record the number of spots and the Rf values from the spot(s).

8. While the plate is developing set up a clean and dry distillation set up and distil off most of the dichloromethane solvent.

9. The remaining solution of Eugenol in Dichloromethane can be removed using a disposable pipette and placed into a clean pre-weighted vial.

10. The vial can be heated on a steam bath under the hood to remove the small amount of dichloromethane.

11. The pure Eugenol should be weighted to determine the percent oil recovered based on the mass of cloves originally used.


Density of Eugenol: 1.34 g/mL

BP of Eugenol: 40°C

Initial mass of Eugenol: 18.545 g

Mass of vial: 18.0063 g

Mass of Eugenol Oil: 18.434 g

% Recovery

= (18.545 g 18.434 g)/18.434 x 100 = 0.602%

Thin layer chromatography:

Rf=(Distance substance moved/Distance solvent moved)




The experiment was successful in that we did isolate eugenol as proven by thin layer chromatography. Our Rf value was somewhat high. This is probably because the beaker with the chloroform was not 100 % closed during the time we did the thin layer chromatography. Our watch glass was not 100% efficient. Also when we were heating the liquid in the condenser, heating the liquid at a rate too high could cause excess materials to come out in the final product.

Other than that, human error is a concern. This can be minimized by careful observation, and proper procedure. Still, our percent error was under 1 percent, which is very favorable.

Warning! This essay is not original. Get 100% unique essay within 45 seconds!


We can write your paper just for 11.99$

i want to copy...

This essay has been submitted by a student and contain not unique content

People also read