The specific heat capacity of the substance Essay

Published: 2020-02-22 13:52:29
843 words
4 pages
printer Print
essay essay

Category: Determine

Type of paper: Essay

This essay has been submitted by a student. This is not an example of the work written by our professional essay writers.

Hey! We can write a custom essay for you.

All possible types of assignments. Written by academics

GET MY ESSAY
CONCLUSION Resulting from the three experiments, I was able to work out average for the energy used and temperature, which I used to work out the temperature rise. To be able to analyse the results properly and accurately I decided to plot a graph using the average temperature rise against energy used. When I plotted the graph, the out come of the results was a straight line when I drew a linear line of best fit. The out come of my graph agrees with my prediction, which stated that the results should produce a straight line on the graph and it would not go through the origin in the real world.

To be able to work our the specific heat capacity I had to draw a gradient on the graph and use the value from it: c = Energy Mass Temperature Change Using the gradientTo be able to work out the specific heat capacity the mass must be included which The value that I worked out for the specific heat capacity of ethanol is 2353Jkg- K-.This value agrees with my prediction that the value will be between 2000 and 3000 and to be much lower than the specific heat capacity of water.

The specific heat capacity that was produced by the gradient, 2353Jkg- K- is only 57 away from the actual specific heat capacity of ethanol, which is 2410Jkg- K- . If both values were to be rounded to two significant figures the values would be exactly the same (2400Jkg- K- ) which shows how close how close the value i worked out is to the real value.

The Fact that ethanol is a liquid but has a significantly lower specific heat capacity compared to water this can be explained by the fact that ethanols is more dense than water and its particles are much closer together than those of water which makes it easier for heat to be conducted easily by particles in ethanol. This also explains why the boiling point of ethanol, (78. 3 c) is lower than that of water which is 100 c and this also supports my understanding and prediction that ethanol requires less heat than water. EVALUATION The experiment procedure that I chose for my investigation is reliable able minimised the margins of errors.

This is supported by the fact that all my results were all on of very close to the line of best fit on the graph. The fact that when I used error-bars they were all being touched by the line and the R^2 value is 0. 9982 and no anomalous results strongly suggest that the procedure was reliable. The fact that there are no anomalous results and the R&2 value is very close to 1 means that the measuring equipments and technique were very accurate and this is supported by the fact that the all observation all produced readings which are very similar to each other which helped to obtain good averages.

The fact that I used a joule meter a part from using voltmeter and ammeter then working out the energy myself eliminated any calculation errors. Even though the measuring techniques and equipments helped produce reliable results, there are still errors in the experiment because the line didnt go through the origin and the value that I worked out for the specific heat capacity is a bit less compared to the actual value. The procedure I used produced errors, which affected the whole experiment.

The errors that caused by the procedure are that the all the electrical heating was not all used to heat ethanol because some heat had escaped through convection, as the air in the room was cooler. Some energy was used to heat up the heat, heat up the beaker and thermometer. The fact that the lid did not cover the whole top because of the gaps for the heater and thermometer was being converted to the cooler air in the room.

The limitation from the experiment that stopped me from obtaining a value that is 100% accurate was the heat loss through convection and these can be improved by using a lid that covers the entire top and the gaps for thermometer and heater dont have any space for air to enter or escape. The fact that some heat energy goes towards heating up the equipments, the equipments should be kept in a temperature that when any electrical energy is given it will all be used to heat up the ethanol and beaker to be wrapped with good insulators so any heat conducted to the beaker will not escape.

Doing all these will decrease the amount of heat that is being used in other way than heating the substance. The main sources or errors would be the taking and recording of the readings. I had to observe and record both readings every minute, which meant that some records were few seconds late or early. This explains the reason the experiments producing minor differences when repeated. The way to overcome this problem is to have three people taking single reading and these would increase the accuracy of the results.

Warning! This essay is not original. Get 100% unique essay within 45 seconds!

GET UNIQUE ESSAY

We can write your paper just for 11.99$

i want to copy...

This essay has been submitted by a student and contain not unique content

People also read